What are the Safety Protection Systems of the High and Low Temperature Test Chamber?
1, Leakage/surge protection:Leakage circuit breaker leakage protection FUSE.RC electronic surge protection from Taiwan
2, The controller internal self-automatic detection and protection device
(1) Temperature/humidity sensor: The controller controls the temperature and humidity in the test area within the set range through the temperature and humidity sensor
(2) Controller overtemperature alarm: when the heating tube in the chamber continues to heat up and exceeds the temperature set by the internal parameters of the controller, the buzzer in it will alarm and need to be manually reset and reused
3, Fault detection control interface: external fault automatic detection protection Settings
(1) The first layer of high temperature overtemperature protection: operation control overtemperature protection Settings
(2) The second layer of high temperature and overtemperature protection: the use of anti-dry burning overtemperature protector to protect the system will not be heated all the time to burn the equipment
(3) Water break and air burning protection: humidity is protected by anti-dry burning overtemperature protector
(4) Compressor protection: refrigerant pressure protection and over-load protection device
4, Fault abnormal protection: when the fault occurs, cut off the control power supply and the fault cause indication and alarm output signal
5, Automatic water shortage warning: the machine water shortage active warning
6, Dynamic high and low temperature protection: with the setting conditions to dynamically adjust the high and low temperature protection value
Get A Quote
IPv6 network supported